[wxqc] Failing Baro L3 Spatial Consistency

Ted Lum gladstonefamily73.net at tedlum.com
Sat Jun 18 08:24:01 CDT 2016


It looks like you may not be sending Altimeter pressure. It also looks 
like the pressure may not be calibrated. Check your software to be sure 
it supports Altimeter pressure and be sure it's configured correctly to 
do so. Then, determine if it needs calibration.

On 6/18/2016 3:01 AM, Wayne Thomas wrote:
> Hello,
> I have a situation that I would like to correct but have been unable 
> to do so. My station which was replaced as part of an upgrade program 
> last fall is failing the above mentioned test. I have tried relocation 
> and basically everything I can think of except using offsets in the 
> software which I try to resist doing as in some cases it only masks a 
> problem.
>
> Anyway you can see the data here and the accompanying fault 
> description 
> *http://weather.gladstonefamily.net/site/C8217?baro_date=2016-06-08#baro
> *
>
> Website data is located here *http://www.smythweather.net
> *
> The station is a normally aspirated Davis VP2 .  I have had a look at 
> the surrounding data and honestly it doesn't look encouraging as to 
> what I need to do for a correction to this problem.
>
> Any suggestions much appreciated !!
>
>
> Thanks In Advance For Your Time!
>
>
>
> Regards,
> Wayne 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://server.gladstonefamily.net/pipermail/wxqc/attachments/20160618/6491b25a/attachment.html>


More information about the wxqc mailing list