[wxqc] WS-3610 wiring, console does not read wind, rain, outside temp.

[Ed]

hello,
did you pay close attention to the power up section, batts in thermo sensor, 
the power to console and wait 15 minutes??
just start over.
Good luck

Relearn Mode (Relearn Tx) ® Allows the WS-3610 to relocate

the outdoor transmitter (for example, after a changing a battery

in the Thermo-Hygro) without the necessity of a complete resetup

of all system components ® Acknowledge with


CONFIRM
.

3.2 Power Supply

Power can be supplied to the Weather Center using batteries or

the AC adapter. In the case that the AC adapter is used, it will

provide all required power to the system if the Base Station and

Thermo-Hygro Sensor are wired directly together.

3.2.1 Use Batteries for Power:

- First insert two Type C alkaline 1.5 V batteries into the

battery compartment of the Thermo-Hygro-Sensor.

- Immediately after, insert three Type AA alkaline 1.5 V

batteries into the battery compartment of the Touch Screen

Base Station.

3.2.2 Use AC Adapter for Power:

- First insert two Type C alkaline 1.5 V batteries into the

battery compartment of the Thermo-Hygro-Sensor.

- Immediately after, connect the AC adapter to the Base

Station, and then plug it into an AC outlet.

- When the AC adapter is used, batteries may also be placed

in the Base Station to serve as a backup power supply if

there is a power outage.

Note: In either case, it is important to observe this order of

succession because the Sensor will send an identification

code that must be received and stored by the Base Station

within the first few minutes of operation.

----- Original Message ----- 
From: "Richard Ray, KI4PEQ" <richardray at cox.net>
To: <wxqc at lists.gladstonefamily.net>
Sent: Thursday, April 05, 2007 12:43 AM
Subject: [wxqc] WS-3610 wiring, console does not read wind, rain,outside 
temp.


> Hello to all,
>
> I have a problem that I am trying to solve with my LaCrosse WS-3610.
> Intermittently, it had been giving wild readings, but now all I can
> get the console to display is inside temperature and barometric
> pressure. All other sensors are inoperative. I am getting 3.5 volts
> across the red and black conductors on the feed wire all the way to
> the outside temperature sensor. I assume the green and yellow wires
> feed back data to the console. No joy either wired or wireless. Any
> ideas as to what could have gone wrong? Until I get things fixed AS
> 318 KI4PEQ reporting is offline. If the unit cannot be repaired, I
> have an Oregon Scientific wireless unit on the way so that I can
> resume reports within the next week to ten days.
>
> Regards,
> Richard
>
>
>
> Richard L. Ray
> KI4PEQ at arrl.net
>
>
>
>
> _______________________________________________
> wxqc mailing list
> Post messages to wxqc at lists.gladstonefamily.net
> To unsubcribe or change delivery options, please go to:
> http://server.gladstonefamily.net/mailman/listinfo/wxqc
>
> The contents of this message are the responsibility of the author.