[wxqc] Vantage Pro2

[Chris Flory]

Addendum to my previous email:

 

I have taken apart the VP2, to see if there were any obstructions or
problems with the temp/hum sensor.  The fan inside is spinning just fine.

 

I did not see any problems, and put it back together.  Now it is working
fine, but I am only at 80deg. F right now.  I will see what happens later
when it gets back up to temp.

 

I am just wondering if there is a problem over 95F with this sensor.no
response from Davis or the place I bought it from yet..probably don't work
the weekends :(

 

  _____  

From: wxqc-bounces at lists.gladstonefamily.net
[mailto:wxqc-bounces at lists.gladstonefamily.net] On Behalf Of Chris Flory
Sent: Sunday, October 01, 2006 10:03 AM
To: wxqc at lists.gladstonefamily.net
Subject: [wxqc] Vantage Pro2

 

I have already engaged Davis support on this, but I was wondering if anyone
else has seen this problem, while I await their feedback.

 

I just bought this VP2 with fan aspirated radiation shield, and it is about
96deg. F outside right now.  The 'temp out' and 'dew point' readouts on the
console are dashed out..it comes and goes, sometimes I see the temp/DP, then
next I see dashes.

 

All other readouts are showing up fine, and I have good communications from
the ISS to the console.

 

Anyone ever have a problem like this?  I have the latest firmware on it.

 

Thanks!

 

-Chris

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://server.gladstonefamily.net/pipermail/wxqc/attachments/20061001/1f6f1f84/attachment.html